Door sill STAINLESS STEEL FIAT FIORINO 2007 2021 STAINLESS STEEL 2 PIECES
Reference : 2521092N
FIAT FIORINO - QUBO
(2007 - 2021)
POLISHED STAINLESS STEEL
2 PIECES
POLISHED STAINLESS STEEL EXTERIOR DOOR SILLS :
The STAINLESS STEEL door sills effectively protect the edges of your FIAT FIORINO against dents and scratches that may occur during entry and exit. In addition, they give your FIAT FIORINO a high-end appearance. This high-quality accessory is made in Europe.
Vehicle-specific chrome accessory
Product features:
Chrome products are manufactured with a molding system specifically for the vehicle part on which they will be applied.
Chrome products are made from A-grade 304 stainless steel.
Products are shipped ready to be installed with high-quality double-sided acrylic tape on the back.
Warranty:
Bright chrome stainless steel products; It is covered by a 5-year warranty against rust.
Assembly instructions:
Install in a dry and dust-free environment.
After removing the product from its packaging, make sure to practice fitting it in the area where it will be applied without removing the protective surface of the double-sided adhesive tape.
Thoroughly clean the surface to which the product will be glued with a cleaning liquid (alcohol, rubbing alcohol, cellulosic thinner, etc.). (Do not clean with liquids containing additives such as scented cologne, wet wipes, gasoline, etc.) Floor cleaning is very important for installation. Plastic parts with a greasy and shiny surface, such as glass seals and door protection strips, must be cleaned until this surface disappears.
If the product contains an adhesive-reinforcing « Primer » wipe (Primer: It is a chemical liquid to be applied to plastic surfaces. It cannot/should not be used on painted vehicle surfaces), apply it to the cleaned surface only on the cleaned surface. Area where the tapes on the back of the product will stick and where the product will cover. (Be careful not to apply it to parts where the product will not stick/cover)
The ambient temperature must be above 25°C for the double-sided adhesive tape on the back of the product to show all its properties. After removing the protective surface of the tape, use a hairdryer, etc. to increase the adhesion force. Apply heat to the tape using
After removing the protective surface of the adhesive tape on the back of the product and applying heat, immediately apply the product to the cleaned and, if necessary, primed area. Make sure it adheres well by applying pressure with a dry cloth. For the product to adhere well, protect it from water for 24 hours and make sure not to wash your vehicle with pressurized water for 48 hours.
SHIPPING TIME 2 TO 15 DAYS
