• Baguette Porte FORD KUGA 2013 2020 INOX CHROME Set Complet 4 PIECES
  • Baguette Porte FORD KUGA 2013 2020 INOX CHROME Set Complet 4 PIECES - Access Auto 4x4
  • Baguette Porte FORD KUGA 2013 2020 INOX CHROME Set Complet 4 PIECES - Access Auto 4x4

Door Trim FORD KUGA 2013 2020 STAINLESS STEEL CHROME Complete Set 4 PIECES

Reference : AC5919400


€84.50
Tax included

FORD KUGA

(2013 - 2020)

STAINLESS STEEL CHROME

4 PIECES

STAINLESS STEEL CHROME DOOR TRIM SET 4 PIECES:

Front TRIM 95 cm Rear TRIM 60 cm

Chrome + ABS plastic door protection strip 8 pieces
(The product is sent in 4 pieces by combining ABS plastic slats filled from the bottom and chrome slats.)
The product can be used in car parks and on walls...

These stainless steel pieces cover the original door trims (black plastic part) to transform them into a chrome finish and are fixed with: 3M double-sided tape, decorative, they will serve for many years. Very simple installation. Delivered with assembly instructions.

However, these door trims cannot replace any original door trims which are generally clipped and not glued.

Material: STAINLESS STEEL CHROME

Delivery content: 4 PIECES + assembly instructions

Vehicle-specific chrome accessory

Product features :
Chrome products are manufactured with a molding system specifically for the vehicle part to which they will be applied.
Chrome products are made from A-grade 304 stainless steel.
Products are shipped ready to install with high-quality double-sided acrylic tape on the back.


Warranty :
Bright chrome stainless steel products; It is covered by a 5-year warranty against rust.

Assembly instructions :
Install in a dry and dust-free environment.
After removing the product from its packaging, be sure to perform fitting exercises on the area where it will be applied without removing the protective surface of the double-sided adhesive tape.
Thoroughly clean the surface to which the product will be glued with a cleaning liquid (alcohol, rubbing alcohol, cellulosic thinner, etc.). (Do not clean with liquids containing additives such as scented cologne, wet wipes, gasoline, etc.) Floor cleaning is very important for installation. Plastic parts with a greasy and shiny surface, such as glass seals and door protection strips, must be cleaned until this surface disappears.
If the product contains an adhesive-strengthening « Primer » wipe (Primer: It is a chemical liquid to be applied to plastic surfaces. It cannot/should not be used on painted vehicle surfaces), apply it to the cleaned surface only on the cleaned surface. Area where the tapes on the back of the product will stick and where the product will cover. (Be careful not to apply it to parts where the product will not stick/cover)
The ambient temperature must be above 25°C for the double-sided adhesive tape on the back of the product to show all its properties. After removing the protective surface of the tape, use a hairdryer, etc. to increase the adhesion strength. Apply heat to the tape using
After removing the protective surface of the adhesive tape on the back of the product and applying heat, immediately apply the product to the cleaned and, if necessary, primed area. Make sure it adheres well by applying pressure with a dry cloth. For the product to adhere well, protect it from water for 24 hours and be careful not to wash your vehicle with pressurized water for 48 hours.

SHIPPING TIME 2 to 15 days

Delivery times

Expédition sous 2 à 15 jours selon disponibilité

Payment possible in 3 or 4 times without fees with ONEY

Recently viewed products

Loading...