Door Trim VOLKSWAGEN GOLF 2013 2020 STAINLESS STEEL CHROME Complete Set 4 PIECES
Reference : AC7651400
VOLKSWAGEN GOLF 7 SEDAN
(2013 - 2020)
STAINLESS STEEL CHROME
SET OF STAINLESS STEEL CHROME DOOR TRIMS 4 PIECES:
These stainless steel pieces cover the original door trims (black plastic part) to transform them into a chrome finish and are fixed with: 3M double-sided tape, decorative, they will serve for many years. Very simple installation. Delivered with assembly instructions.
However, these door trims cannot replace any original door trims which are generally clipped and not glued.
Note: Front piece 100 cm, Rear piece 56 cm
Chrome plastic + ABS door protection strip 8 pieces
(The product is sent in 4 pieces by combining ABS plastic slats filled from the bottom and chrome slats.)
The product offers protection against damage to your vehicle's door when opening the door in parking areas and near walls.
It applies to the flat part of your vehicle's side door. Read the assembly instructions in the description.
Product features :
Chrome products are made from A304 quality stainless steel.
Products are sent ready to be assembled with high quality double-sided acrylic tape on the back (the product is sent in 4 pieces by combining the bottom-filled ABS plastic slat and the chrome slats.)
Warranty:
Bright chrome stainless steel products are covered by a 5-year warranty against rust.
Assembly instructions :
Install in a dry and dust-free environment.
After removing the product from its packaging, without removing the protective surface of the double-sided adhesive tape, an installation exercise is performed at the place where it will be applied, leaving a space of 2-3 mm in the middle of the door so as not to prevent the opening and closing of the doors. The suitability of the middle part of the product is checked by opening and closing the rear door.
Carefully clean the surface on which the product will be glued with a clean cloth (Do not clean with liquids containing additives such as perfumed cologne, wet wipes, gasoline, etc.) Floor cleaning is very important for installation.
The ambient temperature must be above 25°C for the double-sided adhesive tape on the back of the product to show all its properties. After removing the protective surface of the tape, use a hairdryer, etc. to increase the adhesion strength. Apply heat to the strip using
Remove the protective surface of the adhesive tape on the back of the product, apply heat then stick it in one go. Assure that it adheres well by applying pressure with a dry cloth. For the product to adhere well, protect your vehicle from water for 24 hours and make sure not to wash it with pressurized water for 48 hours.
Material: STAINLESS STEEL CHROME
Delivery content: 4 PIECES + assembly instructions
Easy installation with double-sided adhesive tape, it only takes a few minutes, no cutting, no drilling
custom-made and vehicle-specific
SHIPPING TIME 2 to 15 days depending on product availability
Delivery times
DELAI EXPEDITION 2 à 15 JOURS OUVRES SELON DISPONIBIITE
Recently viewed products
