Door Sills HYUNDAI I 40 2011 TODAY STAINLESS STEEL 4 PIECES
Reference : AC3215131
HYUNDAI I 40 SEDAN - WAGON
(2011 - TODAY-)
STAINLESS STEEL CHROME
4 pieces
STAINLESS STEEL DOOR SILLS SET 4 PIECES
The moldings are fixed with: 3M double-sided tape, decorative, they will serve for many years. Very simple installation. Delivered with assembly instructions.
The set includes 4 pieces to equip both sides of the vehicle (right side and left side).
Vehicle-specific chrome accessory
Product features:
Chrome products are manufactured with a molding system specifically for the vehicle part to which they will be applied.
Chrome products are made from A-grade 304 stainless steel.
Products are shipped ready to be installed with high-quality double-sided acrylic tape on the back.
Warranty:
Bright chrome stainless steel products; It is covered by a 5-year warranty against rust.
Assembly instructions:
Install in a dry and dust-free environment.
After removing the product from its packaging, make sure to perform fitting exercises on the area where it will be applied without removing the protective surface of the double-sided adhesive tape.
Carefully clean the surface to which the product will be glued with a cleaning liquid (alcohol, rubbing alcohol, cellulosic thinner, etc.). (Do not clean with liquids containing additives such as perfumed cologne, wet wipes, gasoline, etc.) Floor cleaning is very important for installation. Plastic parts with a greasy and shiny surface, such as glass seals and door protection strips, must be cleaned until this surface disappears.
If the product contains an adhesive-reinforcing « Primer » wipe (Primer: It is a chemical liquid to be applied to plastic surfaces. It cannot/should not be used on painted surfaces of the vehicle), apply it to the cleaned surface only on the cleaned surface. Area where the tapes on the back of the product will stick and where the product will cover. (Be careful not to apply it to parts where the product will not stick/cover)
The ambient temperature must be above 25°C for the double-sided adhesive tape on the back of the product to show all its properties. After removing the protective surface of the tape, use a hairdryer, etc. to increase the adhesion strength. Apply heat to the tape using
After removing the protective surface of the adhesive tape on the back of the product and applying heat, immediately apply the product to the cleaned and, if necessary, primed area. Make sure it adheres well by applying pressure with a dry cloth. For the product to adhere well, protect it from water for 24 hours and make sure not to wash your vehicle with pressurized water for 48 hours.
Scope of delivery: 4-piece side bar + assembly instructions
Easy installation with double-sided adhesive tape, it only takes a few minutes, no cutting, no drilling
custom-made and vehicle-specific
THIS PRODUCT IS ONLY DESIGNED FOR MODELS THAT DO NOT HAVE ORIGINAL DOOR MOLDINGS
DOES NOT REPLACE ORIGINAL DOOR MOLDINGS WHICH ARE MOST OF THE TIME CLIPPED ON THE VEHICLE
SHIPPING TIME 2 to 15 DAYS depending on availability
