Trunk Sill VOLKSWAGEN T5 TRANSPORTER 2003 2015 STAINLESS STEEL double doors
Reference : AC235457
VW T5 TRANSPORTER - CARAVELLE - MULTIVAN (DOUBLE DOORS)
(2003 - 2010) / (2010 - 2015)
POLISHED STAINLESS STEEL
STAINLESS STEEL TRUNK SILL PROTECTION WITH EDGES (exterior):
this ribbed trunk sill protection effectively protects against dents and scratches during loading and unloading. Thanks to its shape, like the ribbed pattern on the top, it is made so that it perfectly matches the design of the VOLKSWAGEN T5.
And if you ever want to replace the protector after intensive use, that's also possible. It will be much cheaper than repainting your bumper.
This trunk sill is made of high-quality V2A stainless steel and is supplied with a complete mounting kit and clear installation instructions. Installation is very easy because the product is equipped with double-sided adhesive tape.
Assembly instructions:
Install in a dry and dust-free environment.
After removing the product from its packaging, be sure to perform fitting exercises on the area where it will be applied without removing the protective surface of the double-sided adhesive tape.
Carefully clean the surface to which the product will be glued with a cleaning liquid (alcohol, rubbing alcohol, cellulosic thinner, etc.). (Do not clean with liquids containing additives such as scented cologne, wet wipes, gasoline, etc.) Floor cleaning is very important for installation. Plastic parts with a greasy and shiny surface, such as glass seals and door protection strips, must be cleaned until this surface disappears.
If the product contains an adhesive-reinforcing « Primer » wipe (Primer: It is a chemical liquid to be applied to plastic surfaces. It cannot/should not be used on painted vehicle surfaces), apply it to the cleaned surface only on the cleaned surface. Area where the tapes on the back of the product will stick and where the product will cover. (Be careful not to apply it to parts where the product will not stick/cover)
The ambient temperature must be above 25°C for the double-sided adhesive tape on the back of the product to show all its properties. After removing the protective surface of the tape, use a hairdryer, etc. to increase the adhesion force. Apply heat to the strip using
After removing the protective surface of the adhesive tape on the back of the product and applying heat, immediately apply the product to the cleaned and, if necessary, primed area. Make sure it adheres well by applying pressure with a dry cloth. For the product to adhere well, protect it from water for 24 hours and be careful not to wash your vehicle with pressurized water for 48 hours.
DELIVERY WITHIN 2 to 6 working days
