Trunk Sill VOLKSWAGEN CADDY MAXI 2008 2021 BLACK STAINLESS STEEL
Reference : ACVWC245219
VOLKSWAGEN CADDY MAXI
(2008 - TODAY- )
TRUNK SILL PROTECTION WITH EDGES (exterior):
this trunk sill protection with edges effectively protects against dents and scratches during loading and unloading. Thanks to its shape, like the ribbed pattern on the top, it is made to perfectly match the design of the VW CADDY MAXI. And if you ever want to replace the protector after intensive use, that’s also possible. It will be much cheaper than repainting your bumper.
BLACK STAINLESS STEEL 1 piece
This trunk sill protection is made of high quality V2A stainless steel and comes with clear installation instructions. Installation is very easy, because the product is equipped with firmly adhering double-sided adhesive tape.
Mounting instructions:
Install in a dry and dust-free environment.
After removing the product from its packaging, be sure to practice fitting it on the area where it will be applied without removing the protective surface of the double-sided adhesive tape.
Carefully clean the surface to which the product will be glued with a cleaning liquid (alcohol, rubbing alcohol, cellulose thinner, etc.). (Do not clean with liquids containing additives such as perfumed cologne, wet wipes, gasoline, etc.) Floor cleaning is very important for installation. Plastic parts with a greasy and shiny surface, such as glass seals and door protection strips, must be cleaned until this surface disappears.
If the product contains an adhesive-reinforcing « Primer » wipe (Primer: It is a chemical liquid to be applied to plastic surfaces. It cannot/should not be used on painted vehicle surfaces), apply it to the cleaned surface only on the cleaned surface. Area where the tapes on the back of the product will stick and where the product will cover. (Be careful not to apply it to parts where the product will not stick/cover)
The ambient temperature must be above 25°C for the double-sided adhesive tape on the back of the product to show all its properties. After removing the protective surface of the tape, use a hairdryer, etc. to increase the adhesion strength. Apply heat to the tape using
After removing the protective surface of the adhesive tape on the back of the product and applying heat, immediately apply the product to the cleaned and, if necessary, primed area. Make sure it adheres well by exerting a pressure with a dry cloth. For the product to adhere well, protect it from water for 24 hours and make sure not to wash your vehicle with pressurized water for 48 hours.
SHIPPING TIME 2 TO 6 DAYS
Delivery times
LIVRAISON SOUS 2 à 8 jours ouvrés
Recently viewed products
Rear panel on the rear bumper original Peugeot Boxer 1994+ Citroën Jumper 1994+ REF 7238K0
- Brand ORIGINAL ERSATZTEIL (GENUINE PART)
- Original reference (OEM) 735790335
