BOOT SILL TOYOTA YARIS GR 2020 TODAY POLISHED STAINLESS STEEL DESIGN
Reference : AC252039
TOYOTA YARIS GR
(2020 - TODAY-)
POLISHED STAINLESS STEEL DESIGN
POLISHED STAINLESS STEEL DESIGN BOOT SILL PROTECTOR WITH EDGES (exterior):
This boot sill protector with edges effectively protects against dents and scratches during loading and unloading. Thanks to its shape, like the ribbed pattern on the top, it is designed to perfectly match the design of the TOYOTA YARIS. And if you ever want to replace the protector after intensive use, that's also possible. It will be much cheaper than repainting your bumper.
Installation instructions:
Install in a dry and dust-free environment.
After removing the product from its packaging, make sure to practice positioning it on the area where it will be applied without removing the protective surface of the double-sided adhesive tape.
Carefully clean the surface to which the product will be glued with a cleaning liquid (alcohol, rubbing alcohol, cellulosic thinner, etc.). (Do not clean with liquids containing additives such as scented cologne, wet wipes, gasoline, etc.) Floor cleaning is very important for installation. Plastic parts with a greasy and shiny surface, such as glass seals and door protection strips, must be cleaned until this surface disappears.
If the product contains an adhesive-strengthening « Primer » wipe (Primer: It is a chemical liquid to be applied to plastic surfaces. It cannot/should not be used on painted vehicle surfaces), apply it to the cleaned surface only on the cleaned area where the strips on the back of the product will stick and where the product will cover. (Be careful not to apply it to parts where the product will not stick/cover)
The ambient temperature must be above 25°C for the double-sided adhesive tape on the back of the product to show all its properties. After removing the protective surface of the tape, use a hairdryer, etc. to increase the adhesion strength. Apply heat to the strip using
After removing the protective surface of the adhesive tape on the back of the product and applying heat, immediately apply the product to the cleaned and, if necessary, primed area. Make sure it adheres well by applying pressure with a dry cloth. For the product to adhere well, protect it from water for 24 hours and make sure not to wash your vehicle with pressurized water for 48 hours.
DELIVERY WITHIN 2 to 6 working days
