SKODA YETI CITY 2013 2017 POLISHED STAINLESS STEEL BOOT SILL
Reference : AC235249
SKODA YETI CITY
(2013 - 2017)
POLISHED STAINLESS STEEL
STAINLESS STEEL BOOT SILL PROTECTION WITH EDGES (exterior):
This boot sill protection with edges effectively protects against dents and scratches during loading and unloading. Thanks to its shape, like the ribbed pattern on top, it is designed to perfectly match the design of the SKODA YETI. And if you ever want to replace the protector after intensive use, that's also possible. It will be much cheaper than repainting your bumper.
This boot sill is made of high-quality V2A stainless steel and comes with a complete mounting kit and clear installation instructions. Installation is very easy because the product is equipped with double-sided adhesive tape.
Installation instructions:
Install in a dry and dust-free environment.
After removing the product from its packaging, make sure to practice positioning it on the area where it will be applied without removing the protective surface of the double-sided adhesive tape.
Carefully clean the surface to which the product will be glued with a cleaning liquid (alcohol, rubbing alcohol, cellulose thinner, etc.). (Do not clean with liquids containing additives such as perfumed cologne, wet wipes, gasoline, etc.) Floor cleaning is very important for installation. Plastic parts with a greasy and shiny surface, such as glass seals and door protection strips, must be cleaned until this surface disappears.
If the product contains an adhesive-strengthening « Primer » wipe (Primer: It is a chemical liquid to be applied to plastic surfaces. It cannot/should not be used on painted surfaces of the vehicle), apply it to the cleaned surface only on the cleaned area where the tapes on the back of the product will stick and where the product will cover. (Be careful not to apply it to parts where the product will not stick/cover)
The ambient temperature must be above 25°C for the double-sided adhesive tape on the back of the product to show all its properties. After removing the protective surface of the tape, use a hairdryer, etc. to increase the adhesion strength. Apply heat to the tape using
After removing the protective surface of the adhesive tape on the back of the product and applying heat, immediately apply the product to the cleaned and, if necessary, primed area. Make sure it adheres well by exerting pressure with a dry cloth. For the product to adhere well, protect it from water for 24 hours and make sure not to wash your vehicle with pressurized water for 48 hours.
DELIVERY WITHIN 2 to 6 working days
