Door Handle Covers RENAULT CLIO 4 ESTATE 2012 2019 STAINLESS STEEL 2 FRONT DOORS SENSOR
Reference : 6116045
RENAULT CLIO 4 (ESTATE - SENSOR on the handles)
(2012 - 2019)
STAINLESS STEEL CHROME
2 FRONT DOORS - 4 PIECES
FRONT DOOR HANDLE COVERS STAINLESS STEEL CHROME FINISH 4 PIECES:
These door handles are made of 304 stainless steel, they contain no plastic, do not rust, and are resistant to cold and heat
product + assembly instructions
Vehicle-specific chrome accessory
Product features:
Chrome products are manufactured with a molding system specifically for the vehicle part on which they will be applied.
Chrome products are made from A-grade 304 stainless steel.
Products are shipped ready to be installed with high-quality double-sided acrylic tape on the back.
Warranty:
Bright chrome stainless steel products; It is covered by a 5-year warranty against rust.
Assembly instructions:
Install in a dry and dust-free environment.
After removing the product from its packaging, be sure to perform fitting exercises on the area where it will be applied without removing the protective surface of the double-sided adhesive tape.
Carefully clean the surface to which the product will be glued with a cleaning liquid (alcohol, rubbing alcohol, cellulosic thinner, etc.). (Do not clean with liquids containing additives such as scented cologne, wet wipes, gasoline, etc.) Floor cleaning is very important for installation. Plastic parts with a greasy and shiny surface, such as glass seals and door protection strips, must be cleaned until this surface disappears.
If the product contains a "Primer" wipe reinforcing the adhesive (Primer: It is a chemical liquid to be applied to plastic surfaces. It cannot/should not be used on painted vehicle surfaces), apply it to the cleaned surface only on the cleaned surface. Area where the strips on the back of the product will stick and where the product will cover. (Be careful not to apply it to parts where the product will not stick/cover)
Ambient temperature must be above 25°C for the double-sided adhesive tape on the back of the product to show all its properties. After removing the protective surface of the tape, use a hairdryer, etc. to increase the adhesion strength. Apply heat to the tape using
After removing the protective surface of the adhesive tape on the back of the product and applying heat, immediately apply the product to the cleaned and, if necessary, primed area. Make sure it adheres well by applying pressure with a dry cloth. For the product to adhere well, protect it from water for 24 hours and be careful not to wash your vehicle with pressurized water for 48 hours.
SHIPPING TIME WITHIN 2 TO 15 DAYS
