Trunk Sill PEUGEOT RIFTER 2019 TO TODAY POLISHED STAINLESS STEEL
Reference : 5732091
PEUGEOT RIFTER
(2019 - TO TODAY-)
POLISHED STAINLESS STEEL
1 PIECE
POLISHED STAINLESS STEEL TRUNK SILL PROTECTION (exterior):
this trunk sill protection effectively protects against dents and scratches during loading and unloading. Thanks to its shape, like the ribbed pattern on the top, it is made so that it perfectly adapts to the design of the Audi A4 Avant (B7). And if you ever want to replace the protector after intensive use, that is also possible. It will be much cheaper than repainting your bumper.
Vehicle-specific ABS chrome accessory
Product features:
Chrome products are manufactured with a molding system specifically for the vehicle part on which they will be applied.
ABS chrome products are manufactured in chrome form on ABS plastic.
Products are shipped ready to be installed with high quality double-sided acrylic tape on the back. (Reinforcing silicone can be applied to large products).
Warranty:
ABS chrome products; The chrome plating is covered by a one-year warranty.
Assembly instructions:
Install in a dry and dust-free environment.
After removing the product from its packaging, practice fitting it in the area where it will be applied without removing the protective surface of the double-sided adhesive tape.
Carefully clean the surface on which the product will be glued with a cleaning liquid (alcohol, rubbing alcohol, cellulosic thinner, etc.). (Do not clean with liquids containing additives such as scented cologne, wet wipes, gasoline, etc.) Floor cleaning is very important for installation. Plastic parts with a greasy and shiny surface, such as glass seals and door protection strips, must be cleaned until this surface disappears.
If the product contains an adhesive-reinforcing « Primer » wipe (Primer: It is a chemical liquid to be applied to plastic surfaces. It cannot/should not be used on painted vehicle surfaces), apply it to the cleaned surface only on the cleaned surface. Area where the strips on the back of the product will stick and where the product will cover. (Be careful not to apply it to parts where the product will not stick/cover)
The ambient temperature must be above 25°C for the double-sided adhesive tape on the back of the product to show all its properties. After removing the protective surface of the tape, use a hair dryer, etc. to increase the adhesion strength. Apply heat to the tape using
After removing the protective surface of the adhesive tape on the back of the product and applying heat, immediately apply the product to the cleaned and, if necessary, primed area. Make sure it adheres well by applying pressure with a dry cloth. For the product to adhere well, protect it from water for 24 hours and make sure not to wash your vehicle with pressurized water for 48 hours.
SHIPPING TIME 2 TO 15 DAYS
