Mirror Covers PEUGEOT PARTNER 1996 2008 ABS CHROME 2 PIECES
Reference : 5705111
PEUGEOT PARTNER
(1996-2008)
ABS CHROME
2 pieces
ABS CHROME MIRROR COVERS 2 PIECES:
The Mirror Covers cover the original mirror housings to transform them into a chrome finish and are fixed with: 3M double-sided scotch tape, decorative, they will serve for many years. Very simple installation. Delivered with assembly instructions.
The set includes 2 pieces to equip both sides of the vehicle (right side and left side).
Material: ABS CHROME
Delivery content: 2 PIECES + assembly instructions
Vehicle-specific ABS chrome accessory
Product features:
Chrome products are manufactured with a molding system specifically for the vehicle part to which they will be applied.
ABS chrome products are manufactured in chrome form on ABS plastic.
Products are shipped ready to be installed with high-quality double-sided acrylic tape on the back. (Reinforcing silicone can be applied to wide products).
Warranty:
ABS chrome products; The chrome plating is covered by a one-year warranty.
Assembly instructions:
Install in a dry and dust-free environment.
After removing the product from its packaging, practice fitting it to the area where it will be applied without removing the protective surface of the double-sided adhesive tape.
Carefully clean the surface to which the product will be glued with a cleaning liquid (alcohol, rubbing alcohol, cellulosic thinner, etc.). (Do not clean with liquids containing additives such as scented cologne, wet wipes, gasoline, etc.) Floor cleaning is very important for installation. Plastic parts with a greasy and shiny surface, such as glass seals and door protection strips, must be cleaned until this surface disappears.
If the product contains an adhesive-strengthening « Primer » wipe (Primer: It is a chemical liquid to be applied to plastic surfaces. It cannot/should not be used on painted vehicle surfaces), apply it to the cleaned surface only on the cleaned surface. Area where the tapes on the back of the product will stick and where the product will cover. (Be careful not to apply it to parts where the product will not stick/cover)
The ambient temperature must be above 25°C for the double-sided adhesive tape on the back of the product to show all its properties. After removing the protective surface of the tape, use a hairdryer, etc. to increase the adhesion strength. Apply heat to the tape using
After removing the protective surface of the adhesive tape on the back of the product and applying heat, immediately apply the product to the cleaned and, if necessary, primed area. Make sure it adheres well by applying pressure with a dry cloth. For the product to adhere well, protect it from water for 24 hours and be careful not to wash your vehicle with pressurized water for 48 hours.
SHIPPING TIME 2 TO 15 DAYS
