Grille Insert FORD TRANSIT CUSTOM 2024 PRESENT STAINLESS STEEL CHROME 9 PIECES
Reference : AC5932180
FORD TRANSIT / TOURNEO CUSTOM II
(2024 - PRESENT)
STAINLESS STEEL CHROME
4 pieces
STAINLESS STEEL CHROME GRILLE INSERTS 9 PIECES:
These stainless steel pieces overlay the factory grille slats to transform them into a CHROME finish without removing the grille: they attach directly to the lower tailgate panel via a 3M self-adhesive system located on the back of the piece.
Material: high-quality 304 stainless steel, chrome ABS.
Package contents: trim strip + fitting instructions
Vehicle-specific chrome accessory
Product features:
Chrome products are manufactured using a molding system specifically designed for the vehicle part on which they will be applied.
Chrome products are manufactured from Grade A 304 stainless steel.
Products are shipped ready to install with high-quality double-sided acrylic tape pre-applied to the back.
Warranty:
Bright chrome stainless steel products; covered by a 5-year anti-rust warranty.
Installation instructions:
Install in a dry, dust-free environment.
After removing the product from its packaging, perform dry-fit test runs on the area where it will be applied without removing the protective liner from the double-sided adhesive tape.
Thoroughly clean the surface to which the product will be bonded using a cleaning solution (alcohol, rubbing alcohol, cellulose thinner, etc.). (Do not clean with liquids containing additives such as scented cologne, wet wipes, gasoline, etc.) Surface preparation is critical for proper installation. Plastic parts with a greasy, shiny surface — such as glass seals and door protective strips — must be cleaned until that surface residue is completely gone.
If the product includes a Primer wipe to enhance adhesion (Primer: a chemical liquid to be applied to plastic surfaces only — it cannot/must not be used on painted vehicle surfaces), apply it to the cleaned surface only in the area where the tape strips on the back of the product will bond and where the product will cover. (Take care not to apply it to areas where the product will not bond/cover.)
Ambient temperature must be above 25°C (77°F) for the double-sided adhesive tape on the back of the product to achieve full bonding strength. After removing the protective liner from the tape, use a heat gun or hair dryer to increase adhesion force. Apply heat to the trim strip using
After removing the protective liner from the adhesive tape on the back of the product and applying heat, immediately apply the product to the cleaned and, if necessary, primed area. Ensure firm bonding by pressing down with a dry cloth. To allow the product to bond properly, keep it away from water for 24 hours and avoid pressure washing the vehicle for 48 hours.
SHIPPING TIME 2 TO 15 DAYS
