HONDA ZR-V 2023 TODAY POLISHED STAINLESS STEEL 4 PIECES Door Sill
Reference : AC209012
HONDA ZR-V
(2023 -TODAY-)
POLISHED STAINLESS STEEL
2 PIECES
POLISHED STAINLESS STEEL EXTERIOR DOOR SILLS:
The STAINLESS STEEL door sills effectively protect the edges of your HONDA ZR-V against dents and scratches that may occur during entry and exit. In addition, they give your HONDA ZR-V a high-end appearance. This high-quality accessory is made in Europe.
This product is supplied with clear installation instructions. Installation is very easy because the product is equipped with firmly adhering double-sided adhesive tape.
Assembly instructions:
Install in a dry and dust-free environment.
After removing the product from its packaging, make sure to perform fitting exercises on the area where it will be applied without removing the protective surface of the double-sided adhesive tape.
Carefully clean the surface to which the product will be glued with a cleaning liquid (alcohol, rubbing alcohol, cellulosic thinner, etc.). (Do not clean with liquids containing additives such as scented cologne, wet wipes, gasoline, etc.) Floor cleaning is very important for installation. Plastic parts with a greasy and shiny surface, such as glass seals and door protection strips, must be cleaned until this surface disappears.
If the product contains a "Primer" wipe reinforcing the adhesive (Primer: It is a chemical liquid to be applied to plastic surfaces. It cannot/should not be used on painted surfaces of the vehicle), apply it to the cleaned surface only on the cleaned surface. Area where the strips on the back of the product will stick and where the product will cover. (Be careful not to apply it to parts where the product will not stick/cover)
The ambient temperature must be above 25°C for the double-sided adhesive tape on the back of the product to show all its properties. After removing the protective surface of the tape, use a hairdryer, etc. to increase the adhesion strength. Apply heat to the strip using
After removing the protective surface of the adhesive tape on the back of the product and applying heat, immediately apply the product to the cleaned and, if necessary, primed area. Make sure it adheres well by applying pressure with a dry cloth. For the product to adhere well, protect it from water for 24 hours and make sure not to wash your vehicle with pressurized water for 48 hours.
Shipping Time - ABS Trunk Sill
Shipping within 2 to 8 working days (Possible delay due to health pandemic)
