Fender Flares DACIA DUSTER 2010 2017 COMPLETE SET 12 pieces DESIGN2
Reference : ACDDUST1SET203
DACIA DUSTER
(2010 - 2017)
OFF ROAD PACK : DOOR PROTECTION STRIPS + FENDER FLARES SET DESIGN2 :
DOOR PROTECTION STRIPS ABS (black) (4 pieces):
attaches directly to the bottom of your vehicle's doors using a 3M adhesive system located on the back of each piece
FENDER FLARES SET (8 pieces) BLACK ABS :
complete set delivered: sticks directly to the vehicle's bodywork using a 3M adhesive system
you can thus give your vehicle an "adventurer" look
Install in a dry and dust-free environment.
After removing the product from its packaging, make sure to perform fitting exercises on the area where it will be applied without removing the protective surface of the double-sided adhesive tape.
Carefully clean the surface on which the product will be glued with a cleaning liquid (alcohol, rubbing alcohol, cellulosic thinner, etc.). (Do not clean with liquids containing additives such as scented cologne, wet wipes, gasoline, etc.) Floor cleaning is very important for installation. Plastic parts with a greasy and shiny surface, such as glass seals and door protection strips, must be cleaned until this surface disappears.
If the product contains an adhesive-reinforcing « Primer » wipe (Primer: It is a chemical liquid to be applied to plastic surfaces. It cannot/should not be used on painted surfaces of the vehicle), apply it to the cleaned surface only on the cleaned surface. Area where the strips on the back of the product will stick and where the product will cover. (Be careful not to apply it to parts where the product will not stick/cover)
The ambient temperature must be above 25°C for the double-sided adhesive tape on the back of the product to show all its properties. After removing the protective surface of the tape, use a hairdryer, etc. to increase the adhesion strength. Apply heat to the strap using
After removing the protective surface of the adhesive tape on the back of the product and applying heat, immediately apply the product to the cleaned and, if necessary, primed area. Make sure it adheres well by applying pressure with a dry cloth. For the product to adhere well, protect it from water for 24 hours and make sure not to wash your vehicle with pressurized water for 48 hours
SHIPPING LEAD TIME 1/2 WEEKS
