Air Suspension RENAULT MASTER 2024 TODAY with Compressor and Specific Control Panel
Reference : ACNR147HV614C
Air Suspension RENAULT MASTER 2024 TODAY with Compressor and Specific Control Panel:
Front-wheel drive, chassis-cab included
1 set of additional air springs for the rear axle, to reinforce the standard leaf springs. The air suspension is installed between the chassis and the axle .
Whether the suspension is hard or soft, high or low, the vehicle adapts to the driver's needs by adjusting the air pressure. The air suspension raises and maintains the rear of the vehicle at standard ride height, regardless of vehicle load. This can be done either with the tire inflator during a stop at a service station, or with the integrated compressor (optional).
Advantages:
Better suspension behavior thanks to increased travel.
Less sensitivity to crosswinds.
Better road holding.
Maximum height gain under maximum load.
Reduced braking distance thanks to optimized braking pressure.
Reduced tire wear.
Production and development compliant with ISO 9001 and TÜV standards.
The set is supplied with a parts certificate from RWTÜV Essen. Correct installation must be confirmed by an approved inspection body.
Click here to request the parts certificate and/or installation instructions.
Installation time is approximately 90 minutes (Basic), 210/240/270 minutes (compressor kit for dual-circuit system) or 270 minutes (SmartAir).
Specifics:
- Only for front-wheel drive vehicles with ABS
- CSM1 (with compressor support) and R (with SmartAir) variants are not compatible with the Interstar-e
- Not compatible with hybrid models, standard air suspension, load-dependent brake pressure regulator on axle 2, and level regulator
The air suspension consists of two 8-inch double bellows:
Double bellows are used in most of our air springs. Fully adjustable, they provide increased comfort and safety to the vehicle on the road, regardless of load and road conditions. They require no minimum pressure and offer excellent emergency braking properties. Once fully compressed, they act as a stop. Thanks to its high performance and high safety reserves, our double bellows can be used either as additional air suspension (used in these springs) or as full air suspension, completely replacing the standard suspension.
This kit consists of additional mounting hardware (air hose, T-pieces, etc.) and a panel with 2 filling valves for filling with a tire inflator
Dual-circuit compressor kit: it includes additional mounting hardware (air hose, T-fittings, etc.), a 45-liter compressor, and a dual control panel in the cabin, allowing easy control of the air springs from the cabin. Both bellows can be inflated independently to maximum pressure and deflated to minimum pressure. This allows balancing different loads and ensuring vehicle stability in corners.
SHIPPING TIME WITHIN 1-2 WEEKS
