Trunk Sill FIAT 600 2023 TODAY BLACK STAINLESS STEEL
Reference : AC240353
FIAT 600
(2023 - TODAY-)
BLACK STAINLESS STEEL
1 piece
BLACK STAINLESS STEEL TRUNK SILL PROTECTION 1 PIECE:
This stainless steel trunk sill is glued to the rear bumper of the vehicle. (It sticks directly to the bodywork using a 3M self-adhesive system located on the back of each piece).
Material: BLACK STAINLESS STEEL
Delivery contents: 1 PIECE + assembly instructions
Assembly instructions:
Install in a dry and dust-free environment.
After removing the product from its packaging, be sure to perform fitting exercises on the area where it will be applied without removing the protective surface of the double-sided adhesive tape.
Thoroughly clean the surface to which the product will be glued with a cleaning liquid (alcohol, rubbing alcohol, cellulose thinner, etc.). (Do not clean with liquids containing additives such as scented cologne, wet wipes, gasoline, etc.) Floor cleaning is very important for installation. Plastic parts with a greasy and shiny surface, such as glass seals and door protection strips, must be cleaned until this surface disappears.
If the product contains an adhesive-reinforcing « Primer » wipe (Primer: It is a chemical liquid to be applied to plastic surfaces. It cannot/should not be used on painted surfaces of the vehicle), apply it to the cleaned surface only on the cleaned surface. Area where the strips on the back of the product will stick and where the product will cover. (Be careful not to apply it to parts where the product will not stick/cover)
The ambient temperature must be above 25°C for the double-sided adhesive tape on the back of the product to show all its properties. After removing the protective surface of the tape, use a hairdryer, etc. to increase the adhesive strength. Apply heat to the tape using
After removing the protective surface of the adhesive tape on the back of the product and applying heat, immediately apply the product to the cleaned and, if necessary, primed area. Make sure it adheres well by applying pressure with a dry cloth. For the product to adhere well, protect it from water for 24 hours and make sure not to wash your vehicle with pressurized water for 48 hours.
Customers who bought this product also bought:
Recently viewed products
Roof Bars RENAULT CLIO ESTATE 2008 2013 DESIGN POLISHED ALUMINUM TRANSVERSAL
- Roof bar type TRANSVERSE
