Door Trim for MERCEDES C-CLASS 2014 2019 STAINLESS STEEL 4 PIECES
Reference : AC73244131
MERCEDES C-CLASS Sedan W 205
(2014 - present)
STAINLESS STEEL CHROME
4 pieces
STAINLESS STEEL DOOR TRIM SET 4 PIECES
DOES NOT REPLACE THE VEHICLE'S ORIGINAL TRIM (clipped onto the door). ONLY SUITABLE FOR MODELS NOT EQUIPPED WITH ORIGINAL DOOR TRIM
The trims are attached using: type 3M double-sided tape, decorative, they will last for many years. Very simple installation. Delivered with assembly instructions.
The set includes 4 pieces to equip both sides of the vehicle (right side and left side).
Material: high-quality 304 stainless steel, V2A chrome, stainless steel
Delivery contents: 4-part side bar + assembly instructions
Vehicle-specific chrome accessory
Product features:
The chrome products are manufactured with a molding system specifically for the vehicle part they will be applied to.
The chrome products are made from high-quality class A 304 stainless steel.
The products are shipped ready to install with high-quality double-sided acrylic tape on the back.
Warranty:
Bright chrome stainless steel products; It is covered by a 5-year warranty against rust.
Installation instructions:
Install in a dry and dust-free environment.
After removing the product from its packaging, be sure to perform fitting exercises on the area where it will be applied without removing the protective surface of the double-sided tape.
Thoroughly clean the surface where the product will be adhered with a cleaning liquid (alcohol, rubbing alcohol, cellulose thinner, etc.). (Do not clean with liquids containing additives such as scented cologne, wet wipes, gasoline, etc.) Cleaning the surface is very important for installation. Plastic parts with a greasy and shiny surface, such as glass seals and door protection strips, must be cleaned until this surface is gone.
If the product contains a “Primer” wipe that enhances the adhesive (Primer: This is a chemical liquid to be applied to plastic surfaces. It cannot/should not be used on the painted surfaces of the vehicle), apply it only to the cleaned area where the strips on the back of the product will stick and where the product will cover. (Be careful not to apply it to areas where the product will not stick/cover)
The ambient temperature must be above 25°C for the double-sided tape on the back of the product to show all its properties. After removing the protective surface of the tape, use a hairdryer, etc. to increase the adhesion strength. Apply heat to the trim using
After removing the protective surface of the double-sided tape on the back of the product and applying heat, immediately apply the product to the cleaned and, if necessary, primed area. Ensure it adheres well by applying pressure with a dry cloth. To ensure the product adheres well, protect it from water for 24 hours and avoid washing your vehicle with high-pressure water for 48 hours.
Easy installation with double-sided tape, it only takes a few minutes, no cutting, no drilling
custom-made and vehicle-specific
THIS PRODUCT IS ONLY DESIGNED FOR MODELS THAT DO NOT HAVE ORIGINAL DOOR TRIM
DOES NOT REPLACE ORIGINAL DOOR TRIM WHICH IS MOST OF THE TIME CLIPPED ONTO THE VEHICLE
SHIPPING TIME 2 to 15 DAYS depending on availability
Delivery times
LIVRAISON SOUS 2 à 8 jours ouvrés
Recently viewed products
Genuine Lower Rear Panel Jeep Avenger 2023 2026 REF 52169962
- Brand PRASCO
-
Original reference (OEM)
167373471T
CI3311011
Left Front Wheel Arch Original Fiat 500X 2015+ REF 52034208
- Brand PRASCO
-
Original reference (OEM)
167373471T
CI3311011