Door Trim Mouldings TOYOTA RAV 4 2013 2018 STAINLESS STEEL 4 PIECES
Reference : AC73244131
TOYOTA RAV 4
(2013 - 2018)
STAINLESS STEEL CHROME
4 pieces
STAINLESS STEEL DOOR TRIM MOULDINGS SET 4 PIECES
DOES NOT REPLACE THE VEHICLE'S ORIGINAL MOULDINGS (clipped onto the door). ONLY SUITABLE FOR MODELS NOT EQUIPPED WITH ORIGINAL DOOR MOULDINGS
The trims are fixed with: type 3M double-sided tape, decorative, they will serve for many years. Very simple installation. Delivered with assembly instructions.
The set includes 4 pieces to equip both sides of the vehicle (right side and left side).
Material: high-quality 304 stainless steel, V2A chrome, stainless steel
Delivery contents: 4-part side bar + assembly instructions
Vehicle-specific chrome accessory
Product features:
Chrome products are manufactured with a molding system specifically for the vehicle part on which they will be applied.
Chrome products are made from high-quality class A 304 stainless steel.
The products are shipped ready to install with high-quality double-sided acrylic tape on the back.
Warranty:
Bright chrome stainless steel products; It is covered by a 5-year warranty against rust.
Installation instructions:
Install in a dry and dust-free environment.
After removing the product from its packaging, be sure to perform fitting exercises on the area where it will be applied without removing the protective surface of the double-sided tape.
Carefully clean the surface where the product will be adhered with a cleaning liquid (alcohol, rubbing alcohol, cellulose thinner, etc.). (Do not clean with liquids containing additives such as scented cologne, wet wipes, gasoline, etc.) Surface cleaning is very important for installation. Plastic parts with a greasy and shiny surface, such as glass seals and door protection strips, must be cleaned until this surface is gone.
If the product contains a “Primer” wipe that enhances the adhesive (Primer: This is a chemical liquid to be applied on plastic surfaces. It cannot/should not be used on painted surfaces of the vehicle), apply it only on the cleaned surface where the tape on the back of the product will stick and where the product will cover. (Be careful not to apply it on areas where the product will not stick/cover)
The ambient temperature must be above 25°C for the double-sided tape on the back of the product to show all its properties. After removing the protective surface of the tape, use a hairdryer, etc. to increase the adhesive strength. Apply heat to the trim using
After removing the protective surface of the double-sided tape on the back of the product and applying heat, immediately apply the product to the cleaned and, if necessary, primed area. Ensure it adheres well by applying pressure with a dry cloth. To ensure proper adhesion, protect it from water for 24 hours and avoid washing your vehicle with high-pressure water for 48 hours.
Easy installation with double-sided tape, it only takes a few minutes, no cutting, no drilling
Custom and vehicle-specific
SHIPPING TIME 2 TO 15 DAYS
